Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 50 - 90 seconds
- Pressure:
- Light
- Prepress:
- 10 seconds
- Substrate:
- MP030, MP031 (Part numbers may vary by distributor)
Additional Items Needed
- Lint Roller
Heat Press Method Instructions
Important Note: Allow the substrate to fully cool after the Pre-Press
1. Fully zip the substrate if applicable.
2. Sticky lint roll the white imaging area of the substrate.
3. Put a sheet of protective paper on top of bottom of the press.
4. Place the substrate onto the paper. It doesn’t matter if it’s imaging side face-up or facedown during the pre-press, but press it face-up.
5) Put a sheet of protective paper on top of the substrate.
6. Pre-heat for 10 seconds, as noted.
7. Sticky lint roll the white imaging area of the substrate while warm.
8. Apply a light mist of Adhesive Spray onto the image to be transferred.
9. Place the image facedown onto the face-up substrate and put onto the protective paper on the bottom of the press.
10. Cover with protective paper.
11. Press.
Application Notes: Protect clip by hanging it off the side of your heat press or covering with teflon.