Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 60 seconds
- Pressure:
- Medium
- Prepress:
- 10
- Substrate:
- GSTL72 (Part numbers may vary by distributor)
Additional Items Needed
- Adhesive Spray
- Lint Roller
Heat Press Method Instructions
1. Hover transfer under open heat press for 10 seconds to dry excess moisture.
2. Cover the bottom table of the press with a sheet of protective paper.
3. Place substrate on top of protective paper, lint roll substrate, then top with protective paper for a 10 second pre-press.
4. Secure transfer to substrate using Adhesive Spray.
5. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
6. Top with protective paper and press according to time, temperature, and pressure above. (400 degrees, 1 minute, Medium Pressure)
Sidenote : If you’re going for full coverage of the graduation stole using the DK20, it will have to be done in sections with parts of it hanging over the edge of the table.