Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 60 Seconds
- Pressure:
- Light
- Substrate:
- MA1051 (Part numbers may vary by distributor)
Heat Press Method Instructions
1. Lay down a layer of Fleece, either a blanket or F0014
2. Cover the bottom table of the press with a sheet of protective paper.
3. Secure transfer to substrate using Adhesive Spray or Heat Tape.
4. Place substrate face down, with attached transfer face up, on top of protective paper on bottom table.
5. Top with protective paper and press according to time, temperature, and pressure above.
If doing 2 sides at once, apply Adhesive Spray to both sides of the substrate, press, and let it rest after opening press for 10 seconds before removing transfer to allow it to finish cooking.
*Application notes: too much pressure can cause a "cloudy" image.
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- SUBSTRATE
- TRANSFER
- PROTECTIVE PAPER
- BOTTOM TABLE