Instruction Details
- Temperature:
- 425°F / 218.33°C
- Time:
- 18 Minutes
- Pressure:
- Medium
- Substrate:
- (Part numbers may vary by distributor)
Heat Press Method Instructions
1. Secure transfer to the Pet Bowl using Adhesive Spray.
2. Wrap the Pet Bowl with protective paper. Take care to smooth any and all wrinkles.
3. Secure the DYEWRAP-173 around the Pet Bowl and slide the flange into the opening. Pinch side until flange "snaps".
4. Place into oven and set dwell time to time listed above.
Application notes: The two imaging areas of the large pet bowl are 2.25" x 9.5". You may need to wet the back of the transfer with water to allow it to lay flat against the surface of the bowl. The protective sheet of paper for the large bowl should be 22.5" x 2 5/8".