Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 15 Minutes
- Pressure:
- Medium
- Substrate:
- DB70-CH, DB73-CH (Part numbers may vary by distributor)
Heat Press Method Instructions
1. Secure transfer to the Pet Bowl using Adhesive Spray.
2. Wrap the Pet Bowl with protective paper. Take care to smooth any and all wrinkles.
3. Secure the DYEWRAP07 around the Pet Bowl. Tighten DYEWRAP07 to finger tight, then give it two more turns using a common wrench.
4. Place into oven and set dwell time to time listed above.
Application notes: You may need to wet the back of the transfer with water to allow it to lay flat against the surface of the bowl. The protective sheet of paper for the large bowl should be 3.5" x 19".
Oven Instructions
Instructions for using Sublimation Shrink Wrap and an oven.
400° 13-14 Minutes
1. Cut out design and secure transfer to the pet bowl using heat tape (item 54150). You may need to wet the back of the transfer with water to allow it to lay flat against the surface of the bowl.
2. Place in shrink bag (item SF135)
3. Use heat gun to shrink bag to pet bowl
4. Place into pre heated, 400° oven and set dwell time to 13-14 minutes.
6. Remove from oven
7. Remove shrink bag and image from tumbler
Application notes: When image begins to show though Sublimation Shrink Wrap, your sublimation is complete.
Shrink Instructions
400° 14 Minutes
1. Cut out design and secure transfer to the pet bowl using heat tape (item 54150). You may need to wet the back of the transfer with water to allow it to lay flat against the surface of the bowl.
2. Place in shrink bag (item SF135)
3. Use heat gun to shrink bag to pet bowl
4. Place into pre heated oven and set dwell time to time listed above.
6. Remove from oven
7. Remove shrink bag and image from tumbler
Application notes: When image begins to show though Sublimation Shrink Wrap, your sublimation is complete.