Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 60 seconds
- Pressure:
- Light
- Prepress:
- 20 Seconds
- Substrate:
- HS23, HS21, HS20 (Part numbers may vary by distributor)
Additional Items Needed
- Heat Tape
- Lint Roller
Heat Press Method Instructions
Production of this item is a 2-step process. You will transfer the top, then the bottom, in two separate pressings.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Lint roll the image area of the substrate.
3. Place substrate face up on bottom table, cover with protective paper, and pre-press for 20 seconds.
4. Secure transfer to substrate using Adhesive Spray. You may press the top (cuff), or the bottom. Do not attempt to press both areas at the same time.
5. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
6. Top with protective paper and press according to time, temperature, and pressure above.
Repeat steps 1-6 to transfer the remaining area of the stocking.
Production of this item is a 2-step process. You will transfer the top, then the bottom, in two separate pressings.
Application notes: Watch the video tutorial for the exact procedure with regards to hanging the top off the press and separately pressing the bottom area of stockings.
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- TRANSFER
- SUBSTRATE
- PROTECTIVE PAPER
- BOTTOM TABLE