Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 5 Minutes
- Pressure:
- Medium
- Substrate:
- TWG6X6 (Part numbers may vary by distributor)
Additional Items Needed
- Heat Tape
- Adhesive Spray
- 1/2" Pressing Pad
Heat Press Method Instructions
1. Place Nomex Felt Pad on Bottom Table.
2. Cover the Nomex Felt Pad with a sheet of protective paper.
3. Use Heat Tape or Adhesive Spray to attach your transfer to the tile.
4. Place the tile with imaging side face down, with attached transfer face up, on top of Nomex Felt Pad and protective paper, on bottom table.
5. Top with protective paper and press according to time, temperature, and pressure above.
Application notes: It is quite common for the white coating to exhibit pinholes when the product is held up to a light source. Beware these products are not meant for back lighting. Should any of these products be back lit after sublimation they will be spotted with light shining through. This is not a product anomaly – it is normal.
Very important: Glass Tiles are not suitable for outdoor use.
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- SUBSTRATE
- TRANSFER
- PROTECTIVE PAPER
- NOMEX FELT PAD
- PROTECTIVE PAPER
- BOTTOM TABLE