Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 1 minute 15 seconds
- Pressure:
- Light
- Prepress:
- 20 Seconds
- Substrate:
- FM3660F, FM2436F, FM1824F, 502436, 502030, 501827, FM2214F (Part numbers may vary by distributor)
Heat Press Method Instructions
1. Cover the bottom table of the press with a sheet of protective paper.
2. Place substrate face up on bottom table, cover with protective paper, and pre-press for 20 seconds. Do not skip this step.
3. Secure transfer to substrate using Adhesive Spray or Heat Tape.
4. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
5. Top with protective paper and press according to time, temperature, and pressure above.
Application note: These mats should not be placed into a clothes washer or dryer. They should be washed using a scrub brush and bleach-free laundry detergent, rinsed and line dried. We recommend spray on carpet cleaner used according to the directions on the can.
If floor mat curls after heating, use weights to hold down the sides until cooled.
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- TRANSFER
- SUBSTRATE
- PROTECTIVE PAPER
- BOTTOM TABLE