Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 60 seconds
- Pressure:
- Medium
- Prepress:
- 10 Seconds
- Substrate:
- ZXP004-FLAP, ZXP004, ZXP003-FLAP, ZXP003, ZXP002-FLAP, ZXP002, ZXP001-FLAP, ZXP001 (Part numbers may vary by distributor)
Additional Items Needed
- Adhesive Spray
- Lint Roller
Heat Press Method Instructions
1. Cover the bottom table of the press with a sheet of protective paper.
2. Lint roll the image area of the substrate.
3. Place substrate face up on bottom table, cover with protective paper, and pre-press for 10 seconds.
4. Secure transfer to substrate using Adhesive Spray.
5. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
6. Top with protective paper and press according to time, temperature, and pressure above.
Application notes: Be sure to make a large bleed on your image for the slipper insole (3/4" at least) so it can seep into the edges as you press.
If the Velcro should be too squashed after imprinting, use another piece of Velcro to fluff it up.
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- TRANSFER
- SUBSTRATE
- PROTECTIVE PAPER
- BOTTOM TABLE