Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 50 Seconds
- Pressure:
- Light
- Prepress:
- 10 Seconds
- Substrate:
- 8013 (Part numbers may vary by distributor)
Additional Items Needed
- Adhesive Spray
- Lint Roller
Heat Press Method Instructions
1. Cover the bottom table of the press with a sheet of protective paper.
2. Lint roll the image area of the substrate.
3. Place substrate face up on bottom table, positioned with the white panel on the press and the non-imaging half of the item over the side of the press. Ensure that none of the plastic parts inside the substrate are subjected to heat. Cover with protective paper, and pre-press for 10 seconds.
4. Secure transfer to substrate using Adhesive Spray.
5. Place substrate face up on bottom table, positioned with the white panel on the press and the non-imaging half of the item over the side of the press. Ensure that none of the plastic parts inside the substrate are subjected to heat.
6. Top with protective paper and press according to time, temperature, and pressure above.
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- TRANSFER
- SUBSTRATE
- PROTECTIVE PAPER
- BOTTOM TABLE