Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 1 Minute 20
- Pressure:
- Medium
- Substrate:
- U5765, U5757, U5745, U5679, U5616, PL-MPHONE610 (Part numbers may vary by distributor)
Additional Items Needed
- Heat Tape
Heat Press Method Instructions
1. Cover the bottom table of the press with a sheet of protective paper.
2. Secure transfer to substrate using Adhesive Spray or Heat Tape.
3. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
4. Top with protective paper and press according to time, temperature, and pressure above.
Application note: During pressing, it is normal for trapped moisture to escape through the substrate’s edge foil. Should the edge foil come loose and flake off after transfer, this is indicative of an excessive amount of moisture within the substrate. In this instance, you will need to prepress (and cool) your substrates twice for 30 seconds each, prior to transfer. If the problem persists, contact Condé for replacement plaques.
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- TRANSFER
- SUBSTRATE
- PROTECTIVE PAPER
- BOTTOM TABLE