Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 4
- Pressure:
- Medium
- Substrate:
- SUSL048, SUSL047 (Part numbers may vary by distributor)
Additional Items Needed
- Heat Tape
- Green Pad
Heat Press Method Instructions
1. Cover the bottom table of the press with a sheet of protective paper.
2. Use Heat Tape to attach your transfer to the substrate.
3. Place substrate face up, with attached transfer face down, on top of protective paper, on bottom table.
4. Cover it all with 1/8" Heat Resistant Green Rubber Pad and press according to time, temperature, and pressure above.
Application notes: If you do not use a green pad, your transfer paper may stick to the coaster and it is difficult to remove. Once your green pad heats up, you might want to reduce press time by about 30 seconds.
Additional notes: Note: Dwell time should be increased for darker saturated images. Also, cleaning the slate before pressing is recommended.
Laser Cutting:
35 watt laser at 70% power and 100% speed at 500ppi
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- GREEN PAD
- TRANSFER
- SUBSTRATE
- PROTECTIVE PAPER
- BOTTOM TABLE