Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 1 minute 30 seconds
- Pressure:
- Medium
- Substrate:
- SSC03, SSC016, SSC015, SSC017, (Part numbers may vary by distributor)
Heat Press Method Instructions
1. Cover the bottom table of the press with a sheet of protective paper.
2. Clean face of sandstone with a cloth to remove debris.
3. Secure transfer to substrate using Adhesive Spray or Heat Tape.
4. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
5. Top with protective paper and press according to time, temperature, and pressure above.
Application notes: An 1/8" green pad needs to be used for edge to edge, full bleed designs and 1 minute of time needs to be added if using the pad.
***The imaging side of Sandstone is the brighter white side.
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- TRANSFER
- SUBSTRATE
- PROTECTIVE PAPER
- BOTTOM TABLE
