Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 60 seconds
- Pressure:
- Medium
- Prepress:
- 10 Seconds
- Substrate:
- MP051 (Part numbers may vary by distributor)
Additional Items Needed
- Adhesive Spray
- Lint Roller
Heat Press Method Instructions
1. Cover the bottom table of the press with a sheet of protective paper.
2. Sticky lint roll the image area of the substrate.
3. Place substrate face up on bottom table, cover with protective paper, and pre-press for 10 seconds. Do not skip this step.
4. Secure transfer to substrate using Adhesive Spray.
5. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
6. Top with protective paper and press according to time, temperature, and pressure above.
Application notes:
Place a sheet of protective paper between the handles of the tote bag when pressing to prevent accidental sublimation blow-through to the other side of the tote. Take care to place your image so it fully covers the bottom area of the tote. You may want to use foam or a piece of Nomex to puff out the seam area to get full coverage.
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- TRANSFER
- SUBSTRATE
- PROTECTIVE PAPER
- BOTTOM TABLE
