Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 1 Minute 20
- Pressure:
- Light
- Prepress:
- 10 Seconds
- Substrate:
- APRON1016 (Part numbers may vary by distributor)
Additional Items Needed
- Adhesive Spray
- Lint Roller
Heat Press Method Instructions
1. Cover the bottom table of the press with a sheet of protective paper.
2. Sticky lint roll the image area of the substrate.
3. Place substrate face up on bottom table, cover with protective paper, and pre-press for 10 seconds.
4. Secure transfer to substrate using Adhesive Spray.
5. Place substrate face up, with attached transfer face down, on top of protective paper on bottom table.
6. Top with protective paper and press according to time, temperature, and pressure above.
Application notes:
80 second press time is for doing both panels at once. If doing individual panels, use 60 seconds for each panel. Apron strings may need to be ironed or pressed flat if twisted or curled.
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- TRANSFER
- SUBSTRATE
- PROTECTIVE PAPER
- BOTTOM TABLE