Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 45 seconds
- Pressure:
- Medium to Heavy
- Prepress:
- 10 Seconds
- Substrate:
- MP029 (Part numbers may vary by distributor)
Additional Items Needed
- Lint Roller
Heat Press Method Instructions
1. Sticky lint roll the white imaging area of the substrate.
2. Put a sheet of protective paper on top of bottom of the press.
3. Place the substrate onto the paper with the teeth part of the Velcro hanging off the press
4. Put a sheet of protective paper on top of the substrate.
5. Pre-heat for 10 seconds, as noted.
6. Sticky lint roll the white imaging area of the substrate while warm. Important Note: Allow the substrate to fully cool after the Pre-Press
7. Apply a light mist of Adhesive Spray onto the image to be transferred.
8. Place the image facedown onto the face-up substrate and put onto the protective paper on the bottom of the press, hang the Velcro teeth area off the side of the press.
9. Top with protective paper and press according to time, temperature, and pressure above.
Stack Order for Heat Press
- HEAT PRESS PLATEN
- PROTECTIVE PAPER
- TRANSFER
- SUBSTRATE
- PROTECTIVE PAPER
- BOTTOM TABLE
