Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 45 seconds
- Pressure:
- Medium
- Substrate:
- U4370 (Part numbers may vary by distributor)
Additional Items Needed
- Heat Tape
Heat Press Method Instructions
* Add 2 extra seconds for every additional piece pressed at the same time.
1. Print the transfer.
2. Cover the press with protective paper.
3. Lightly mist transfer with DyeTrans Adhesive Spray.
4. Place the transfer on the FRP, smooth wrinkles.
5) With the transfer attached, place FRP face up on the protective sheet. You must imprint the 2-sided substrates twice. You cannot imprint both sides at the same time.
6. Cover with protective paper.
7. Press with TIME/TEMP/PRESSURE settings listed above.
Double-sided items: Let cool completely, repeat steps 1-6 for second side.
Do not stack items while hot. Place separately on a table to cool. A thin plastic film that must be removed prior to pressing protects some items.
