Instruction Details
- Temperature:
- 385°F / 196.11°C
- Time:
- 45 seconds
- Pressure:
- Light
- Substrate:
- DS040W, DS040SS, DS040SG, DS041W, DS041SS, DS041SG, DS34W (Part numbers may vary by distributor)
Additional Items Needed
- Heat Tape
Heat Press Method Instructions
Too much pressure will cause a mottling of the metal finish.
Use the weight of the platen as pressure if necessary.
1. Use Adhesive Spray and protective paper above and below the substrate.
2. Press Substrate Face-Down
If you should see small watermarks after imaging, try using less pressure. Another method is to press it before removing the peel coat, the image will transfer through the plastic without the watermarks.