Instruction Details
- Temperature:
- 385°F / 196.11°C
- Time:
- 45-55 seconds
- Pressure:
- Light; PSI 10
- Substrate:
- DS004SG, DS004SS, DS004W, DS006SG, DS006SS, DS006W, DS020SG, DS020SS, DS030SG, DS030SS, DS030W, DS032SG, DS032SS, DS032W, DS033SG, DS033SS, DS033W, DS038SG, DS038SS, DS038W, DS039SG, DS039SS, DS039W, DS042SG, DS042SS, DS042W, DS048W, DS053SG, DS053SS, DS053W, DS060SG, DS060SS, DS060W, DS061SG, DS061SS, DS061W (Part numbers may vary by distributor)
Additional Items Needed
- Heat Tape
Heat Press Method Instructions
Remove peel coat from inserts.If bottom platen is cold, begin by preheating for 15 seconds.
1. Lay protective paper on heat press platen.
2. Remove protective film from insert.
3. Lay insert imaging side face-down on transfer. Use heat tape or Adhesive Spray to keep it in place.
4. Add a piece protective paper over your transfer and insert.
5) Press. Add 2-3 seconds for each additional insert imaged at the same time.
NOTE: If you should see a void in the provided glue layer, add a drop of Super Glue to those areas prior to assembly of the product.