Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 8 Minutes
- Pressure:
- Medium
- Substrate:
- SG6819, SG7919, SG1968, SG1979, SG1980 (Part numbers may vary by distributor)
Additional Items Needed
- Heat Tape
- Green Pad
Heat Press Method Instructions
Do NOT mirror or reverse image when printing transfer.
1. Cover the bottom table of the press with a sheet of protective paper.
2. Use Heat Tape to attach your transfer to the substrate.
3. Place the 1/8" thick yellow felt onto the protective paper covering the bottom of the press. Place the plaque, imaging side face-up, onto the yellow felt pad on the bottom table.
4. Cover the front of the plaque with a 1/8" thick green silicone rubber pad.
5. Press with Temp/Time/Pressure settings listed above.
6. After pressing, allow the plaque to cool for a few minutes before removing the transfer.
7. Insert clock.