Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 90 seconds
- Pressure:
- Light
- Prepress:
- 10 seconds
- Substrate:
- HS19 (Part numbers may vary by distributor)
Additional Items Needed
- Adhesive Spray
- Lint Roller
- Nomex Felt
Heat Press Method Instructions
1. Cover the press with a protective sheet of paper.
2. Place the stocking, imaging side face up, on the paper and lint roll the entire area that will come into contact by the press.
3. Place a piece of protective paper between the layers of the fabric (if applicable) to prevent the image bleeding through to the other side.
4. Sticky lint roll on each side of the substrate and pre-press each side of the substrate for 10 seconds.
5. Sticky lint roll the substrate again while warm and then remove from the press and allow cooling.
6. Lightly mist transfer with Adhesive Spray.
7. Place the transfer on the fabric, smooth wrinkles.
8. Cover with protective paper sheet and press. Be sure to use a fresh sheet of protective paper each time.