Instruction Details
- Temperature:
- 400°F / 204.44°C
- Time:
- 70 seconds
- Pressure:
- Light
- Substrate:
- U5961, U6888, U8515, U4422, U4570, U5570, U5613, U5629, U7489, U8624, U8772, U6162 (Part numbers may vary by distributor)
Additional Items Needed
- Heat Tape
Heat Press Method Instructions
Imaging side face-down
1. Place a protective paper on the bottom of the press.
2. Remove the plastic peel coating from the metal – this is the imaging side.
3. Adhere the transfer to the metal using Adhesive Spray or heat tape.
4. Place the substrate, imaging side face-down, onto the protective paper covering the bottom of the press.
5) Press.
6. Remove the transfer from the metal being sure not to touch the imaging area while hot.
Click here for the Unisub Tip Sheet for Cutting this Substrate.